Choosing

Our overview “Characteristics and appropriateness” offers a first help for selection (see page 4 of our complete catalogue). One of our friendly employees would be pleased to help you with a more [...]

Steidle GmbH offers you several systems. Which one is optimum for your use depends on the technical conditions on the one hand (machines, techniques, material, processes etc.) and on the other [...]

If we know customer using a similar application and this customer gives his agreement we can establish such a contact. Otherwise, the multitude of application examples in the complete catalogue / [...]

Normally, 1 nozzle per cutting tool to be lubricated is sufficient. At least 2 nozzles are to be recommended for milling in view of the multi-dimensional traversing directions. For smaller saws [...]

No. Since this could never guarantee a uniform distribution, a nozzle could be undersupplied. In view of the already low minimum quantities a failure of the lubrication system could result.

This is not possible for most of the devices without a larger modification. Therefore the number of the nozzles required should be selected right from the beginning.

Normally 20-50 ml is sprayed per nozzle and spraying hour with the MQL. If this value is multiplied with the effective spraying time per day, you receive the medium consumption of the system per [...]

A float switch is reasonable, if the system with the reservoir is not located in the field of view of the user or if a heavy contamination of the reservoir or the filling level display has to be [...]

In most cases, both can be used for the control which monitors the contact signal of the float switch. However, the NC offers the advantage that a possible parting of a cable in the line is [...]

No. All Steidle systems work exclusively with compressed air. Current is only necessary to open the compressed air supply, if you have selected an electric drive control.